Garage Door Openers, Garage Door Opener Parts, Access Controls, Garage Door Opener Remote Control and Garage Door Keypad

garage-door-openers.us your garage door opener specialists Sales 1-480-247-2094

 

 Home

Contact Us

About Us

Shipping

Follow us on Facebook

1st Garage Door Openers, Inc.
 BBB Business Review

Stanley

Remotes

Receivers

Keyless Entry and Wall Controls

Repair Parts

Telectron

Allister,Allstar

Remotes

Keypads and Wall Controls

Receivers

Repair Parts

Challenger Repair Parts

Tec Key TK1010 Remote

Marantec

Remotes

Repair Parts

LiftMaster

Remotes

Keyless Entry

Repair Parts

Receivers

Logic Boards

Surge Protection

Safety Sensors

Wall Controls

Motor Heads

Garage Door Opener Systems

Battery Backup

Accessories

Multi-Code

Remotes

Keypads

Receivers

Universal

Linear Delta3

Remotes

Keypads

Receivers

Repair Parts

Moore O Matic Parts

Heddolf, ESP Micom

Wayne Dalton

Remote Controls and KeyPads

Wall Controls

Repair Parts

Lubricants

Driveway Alert by Optex

Garage Accessories
Customer Assistance
Shipping and Returns
Warranty Information
Cancellation Policy
About Us
Fax or check Order form
Site Index

All orders are shipped same or next day!!!

VISA, Mastercard, American Express and Discover

Review www.garage-door-openers.us on alexa.com

Wayne Dalton Garage Door Opener Wireless Keyless Entry System KEP2 How To Program Instructions

 

  1. With new installations, it is recommended that the keyless entry be programmed before mounting to wall, otherwise proceed to step B.
  2. Unit can be programmed with the garage door in either up or down position.
  3. Press the transmitter program button on the garage door opener to switch the opener to the transmitter learn mode. The idrive and idrive torsion opener will remain in the learn mode for 30 seconds. The DoorMaster opener will remain in the learn mode for 15 seconds. The Quantum / Classic opener will remain in the learn mode for 60 seconds.
  4. Push the ON/RESET button of the keyless entry.     Keypad will light indicating the unit has been activated and is waiting for commands (illumination may be not be visible in sunlight).
  5. Press the desired four digit PIN number, the hold the 0 key until door moves. (example 1-2-3-4-0). Release 0 key. Programming is now complete.

NOTE: If, at any time, an error was made in entering the codes, simply press the ON/RESET button and repeat the above procedures.

Note: One KEP2 Keyless entry can be programmed to open multiple garage door openers. To program fro additional openers, repeat steps A thru E above except input a different four digit PIN number for each additional opener.

How Your Keyless Entry Operates Your Opener:

The following explains how your keyless entry can be used to OPEN, CLOSE, START, and STOP your door.

  1. Activate your keypad by pressing the ON/RESET button; keypad will illuminate.
  2. Enter your 4-digit PIN (personal identification number); door will begin to move.

NOTE: If you inadvertently enter an incorrect code, the door will not move. Reset with the ON/RESET button and re-enter your PIN number.

  1. Unit remains active for next 15 sec. Pressing any key, except the ON/RESET, will

Stop the door if opening, or reverse the door if closing.

BATTERY REPLACEMENT:

            Under normal operating conditions, the battery should be changed once every 12   

             months. Dispose of used batteries properly. To Replace battery perform the.

             following steps.

A.     Raise Keyless entry Cover to expose battery door.

B.     Snap open door with a coin and remove old battery.

C.     Replace battery (12 volt) with positive terminal to right and snap close battery door.

garage-door-openers.us - Owned by 1st Garage Door Openers, Inc., an independent family owned and operated business serving the Garage Door and Garage Door Opener Industry since 1981.  Providing excellent customer service and assistance for over 25 years. We are a discount reseller of  garage door opener remotes, repair parts, keyless entry and gate operator controls for your home, business, or gated community.   We carry parts for the following garage door openers Lift-Master, Chamberlain, Sears Craftsman, Access Master, Sears Best Craftsman, Sears Automatic Door Opener, Master Mechanic, Security +, Formula 1, Garage Master, Billion Code, LiftMaster Professional, Estate Series, Premium Series, Contractor Series, Power Driver, Whisper Drive, Genie, Alliance, Norelco, Blue-Max, Lift-A-Door, Pro Max, Aladdin, Hercules, Stealth, Excelerator, Intellicode, Genie Pro, OverDrive, Python 2, Signature, Phantom, Legacy, Medallion, CodeDodger, Overhead Door, Genie Shop Vac, Stanley, Vemco, Quiet Glide, SecureCode, Lightmaker, Innovative Products, Whistler, U-Install, Popular Mechanics, Allister, Allstar, Pulsar, MVP, Challenger, GTO, All-O-Matic, Electrolift, Westinghouse, AM/11, Linear, Access Pro, Moore-O-Matic, MegaCode, Delta 3, MultiCode, Heddolf, ESP Micom, Intercontinental Dynamics, Crusader, Wayne Dalton, iDrive, Door Master, Quantum, Classic Drive, Tec Key, Martec, Monarch, Telectron and other garage door openers, and gate operators. All mentioned brand names of Garage Door openers, Garage Door opener receivers and Gate operator devices are registered trade names and trademarks of the respective entities and are only used for reference.

1st Garage Door Openers Inc.

Mesa, AZ  85203

1-480-247-2094

1-480-247-3498   Fax

Garage Door and Garage Door Openers

Copyright 2017 garage-door-openers.us  No part of this site can be reproduced in any form or by any means, photocopying, electronic, mechanical, or otherwise, without the prior written permission of 1st Garage Door Openers Inc.