Garage Door Openers, Garage Door Opener Parts, Access Controls, Garage Door Opener Remote Control and Garage Door Keypad

garage-door-openers.us your garage door opener specialists Sales 1-480-247-2094

 

 Home

Contact Us

About Us

Shipping

Follow us on Facebook

1st Garage Door Openers, Inc.
 BBB Business Review

Stanley

Remotes

Receivers

Keyless Entry and Wall Controls

Repair Parts

Telectron

Allister,Allstar

Remotes

Keypads and Wall Controls

Receivers

Repair Parts

Challenger Repair Parts

Tec Key TK1010 Remote

Marantec

Remotes

Repair Parts

LiftMaster

Remotes

Keyless Entry

Repair Parts

Receivers

Logic Boards

Surge Protection

Safety Sensors

Wall Controls

Motor Heads

Garage Door Opener Systems

Battery Backup

Accessories

Multi-Code

Remotes

Keypads

Receivers

Universal

Linear Delta3

Remotes

Keypads

Receivers

Repair Parts

Moore O Matic Parts

Heddolf, ESP Micom

Wayne Dalton

Remote Controls and KeyPads

Wall Controls

Repair Parts

Lubricants

Driveway Alert by Optex

Garage Accessories
Customer Assistance
Shipping and Returns
Warranty Information
Cancellation Policy
About Us
Fax or check Order form
Site Index

All orders are shipped same or next day!!!

VISA, Mastercard, American Express and Discover

Review www.garage-door-openers.us on alexa.com

LiftMaster Professional Garage Door Openers 378LM Wireless Panel Coding Instructions

 

 

378LM and 378LMC Wireless Control Panel

 

Only for use with 315MHz Security+ garage door openers and universal receivers that have a purple “learn” button.

 

To Program The Large Push Button or Auxiliary Button To A Garage Door Opener

 

1.       Press and release the “learn” button on the motor unit. The learn indicator light will glow steadily for 20 seconds.

2.       Within 30 seconds, press and hold the large push button or auxiliary button on the wireless control panel.

3.       Release the button when the motor unit light blinks. It has learned the code. If the light bulbs are not installed, two clicks will be heard.

 

To Erase All Codes From Motor Unit Memory

 

To deactivate any unwanted remote, first erase all codes:

 

Press and hold the “learn” button on motor unit until the learn indicator light goes out (approximately 6 seconds). All previous codes are now erased. Reprogram each remote or keyless entry you wish to use.

 

To Control the Opener Lights

 

NOTE:  Feature not available with universal receiver.

With 315MHz Security+ wireless control panel, the Light button can be programmed to operate the opener lights without opening the door. A wired multi-fuction control panel is required to program the Light button on the wireless control panel.

1.       With the door closed, press and hold the Light button on the wireless control panel.

2.       Press and hold the Light button on the multi-function control panel.

3.       Press and hold the Lock button on the multi-function control panel.

4.       After the opener lights flash, release all buttons.

Test by pressing the Light button on the wireless control panel.

The opener lights should turn on or off but the door should not move.

 

***************WARNING***************

To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:

·         Install door control within sight or garage door, out of reach of children at a minimum height of 5’ (1.5m), and away from all moving parts of door.

·         NEVER permit children to operate or play with door control push buttons or remote control transmitters.

·         Activate door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel.

·         ALWAYS keep garage door in sight until completely closed. NEVER permit anyone to cross the path of closing garage door.

*******************************************

 

Installation

 

NOTE:  Locate the door control within sight of the door at a minimum height of 5’ (1.5m) where small children cannot reach and away from all moving parts of the door and door hardware.

 

Remove the push button cover by gently prying off the top edge with a screwdriver. Fasten with 6Abx1-1/4” self-tapping screws as follows:

·         Drill pilot holes and install bottom screw, allowing 1/8” (3mm) to protrude above the wall surface.

·         Position bottom of door control on screw head and slide down to secure. Adjust screw for snug fit.

·         Install top screw. DO NOT overtighten, you may damage the plastic housing.

 

The Wireless Control Panel Batteries

***************WARNING***************

To prevent possible SERIOUS INJURY or DEATH:

·         NEVER allow small children near batteries.

·         If battery is swallowed, immediately notify doctor.

*******************************************

 

The Lithium batteries should produce power for up to 5 years. To replace the batteries, remove the two screws and the logic board from the plastic housing. Insert new batteries positive side up (+).

Dispose of old batteries properly.

garage-door-openers.us - Owned by 1st Garage Door Openers, Inc., an independent family owned and operated business serving the Garage Door and Garage Door Opener Industry since 1981.  Providing excellent customer service and assistance for over 25 years. We are a discount reseller of  garage door opener remotes, repair parts, keyless entry and gate operator controls for your home, business, or gated community.   We carry parts for the following garage door openers Lift-Master, Chamberlain, Sears Craftsman, Access Master, Sears Best Craftsman, Sears Automatic Door Opener, Master Mechanic, Security +, Formula 1, Garage Master, Billion Code, LiftMaster Professional, Estate Series, Premium Series, Contractor Series, Power Driver, Whisper Drive, Genie, Alliance, Norelco, Blue-Max, Lift-A-Door, Pro Max, Aladdin, Hercules, Stealth, Excelerator, Intellicode, Genie Pro, OverDrive, Python 2, Signature, Phantom, Legacy, Medallion, CodeDodger, Overhead Door, Genie Shop Vac, Stanley, Vemco, Quiet Glide, SecureCode, Lightmaker, Innovative Products, Whistler, U-Install, Popular Mechanics, Allister, Allstar, Pulsar, MVP, Challenger, GTO, All-O-Matic, Electrolift, Westinghouse, AM/11, Linear, Access Pro, Moore-O-Matic, MegaCode, Delta 3, MultiCode, Heddolf, ESP Micom, Intercontinental Dynamics, Crusader, Wayne Dalton, iDrive, Door Master, Quantum, Classic Drive, Tec Key, Martec, Monarch, Telectron and other garage door openers, and gate operators. All mentioned brand names of Garage Door openers, Garage Door opener receivers and Gate operator devices are registered trade names and trademarks of the respective entities and are only used for reference.

1st Garage Door Openers Inc.

Mesa, AZ  85203

1-480-247-2094

1-480-247-3498   Fax

Garage Door and Garage Door Openers

Copyright © 2017 garage-door-openers.us  No part of this site can be reproduced in any form or by any means, photocopying, electronic, mechanical, or otherwise, without the prior written permission of 1st Garage Door Openers Inc.